Assembly check · lock assembly · demonstration copy

Electrical insulation of the live part

The live part must be insulated from the steel component into which studs 022 are screwed and which is clamped by brackets 016, and from the recess sheet under the box. The steel of the assembly splits into two sides: everything electrically connected to the live part, and everything connected to earth. Between them sit insulators made of ZEDEX, F-4 (PTFE) and rubber. After the design documentation was revised, no places without insulation remain; yellow marks show air gaps that need checking.

Loading the model…
Rotate: left button · pan: right button · zoom: wheel · click: select a part or label

Contact graph

contact air, no insulator air, check

What's left

doneSecond sheet 024 at the cup Sheet 024 at the wall of each beam: 2 per assembly, 8 per product (4 in the documentation). The cup bolts were already in bushings 026 and washers 025 on both sides.
doneStuds 022 in spacers 028 Holes in 028 are ⌀44, with bushings 009 from the documentation (item 21): 4 per assembly, 16 per product.
checkRecess sheet and housing 03 The slot in the recess sheet for the driver rib must be at least 34. How housing 03 is fixed: if it is welded to the recess sheet, the beams' insulation relies on the F-4 alone.

Contact: touching or a gap of up to 1.6 mm (fasteners in holes). Insulator: a material with ρ < 3 g/cm³. The recess sheet was not modelled.